Rayzoon Technologies LLC

mab · Jammer Joined: 10 Nov 2005 Posts: 27

Hi,
I have a situation in where I open a new project in SX3 load Jamstix as a VST instument, in Jamstix select in mapping tab LOAD BFD ALL.rdm, the program automatically switches to BFD ALL.dll. Okay so now I go and work out all my parts in the arranger, l then select the record button on the midi track and record from the beginning to the end. So far okay, I then remove jamstix from the vst rack load BFD as a module, and play back the track. Now for some reason I can't figure out the timing is all off plays out of sync with the tempo. I have all the pocket controls off and timing variance off. I like the hit variance but not the timing to vary. Anyway this is where I am at. The program is cool I just can't seem to get to a point where I can start up a project and go. Also when this is loaded up in SX3 and I minimize SX3 and go to another windows program the sample rate changes to 22.5K any ideas. Thanks for the help, you do a good job of caring for your customers.

Ralph [RZ] · Site Admin Joined: 02 Jan 2008 Posts: 13332

mab · Jammer Joined: 10 Nov 2005 Posts: 27

I would like to pass on some knowledge to those using the Lynx cards. If the system sounds are not disabled this is the cause of the switch between 44.1 and 22.5 sample rates. The card recognizes that the Windows sounds are 22.5 and when you leave Cubase to go to another widows program it switches the sample rate automatically producing the worst hi frequency feedback screech in the process.