Rayzoon Technologies LLC

Fingers · Jam Meister Joined: 09 Apr 2005 Posts: 83 Location: Spain

Not sure if this is a problem, or just something I've failed to do properly.

I've been running through my new download of DrumPak #2 and can't get any sounds at all out of either the Close-Stereo or Rods - Close-Stereo mappings. All the others work fine, so I'm fairly sure it's something I've missed.

I see the samples loading and I know midi is getting to Jamstix. I can even load all the other mappings 'on the fly' (while track is running - the output just mutes while it loads and then springs back into life) but not these two.

Any ideas?

Fingers · Jam Meister Joined: 09 Apr 2005 Posts: 83 Location: Spain

OK - I was going to delete the above since I now have it working, but I thought I should leave it here in case anyone else had the same problem.

I don't know why it happened, but after a lot of fiddling around, these two mappings started to work after I had switched to MIDI-Out only and back again. Normally, I never use this feature, so I can't explain why it should have done this - but it's working now and I don't care Smile

.

Great value for money - Rayzoon have scored yet again!!

Ralph [RZ] · Site Admin Joined: 02 Jan 2008 Posts: 13332

Great it's working but it's still an odd one. Make sure you are running Jamstix 1.42! Check the about tab to be sure!
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

Fingers · Jam Meister Joined: 09 Apr 2005 Posts: 83 Location: Spain

Yes - latest version with the x8-1 beta patch.

It is odd - but then, computers do funny things like this for no apparent reason sometimes and I've ceased to worry about it because life's too short Smile

.