| View previous topic :: View next topic |
| Author |
Message |
big_woody
Jammer
Joined: 04 Mar 2010
Posts: 36
|
 Posted: Thu Mar 18, 2010 3:08 pm Post subject: Can I set the power level for a Part? |
 |
|
Lets say I want the bridge to have a side stick. Can I highlight the part, set the power knob and have it saved/applied to just that part? When I do it now the power knob stays where I put it for the whole song. (Ver2/Jam no input) I see in another thread how to use an envelope in Reaper, which works well, but think it would be cool/quicker to be able to set and save it for an individual part.
Thanks |
|
| Back to top |
|
 |
Ralph [RZ]
Site Admin
Joined: 02 Jan 2008
Posts: 13332
|
| Posted: Thu Mar 18, 2010 5:03 pm Post subject: |
|
|
At this point it can only be done via envelope.
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com |
|
| Back to top |
|
|
big_woody
Jammer
Joined: 04 Mar 2010
Posts: 36
|
| Posted: Thu Mar 18, 2010 5:32 pm Post subject: |
|
|
| Thanks, pretty much a 'nice to have' and I would imagine that you have lots on your plate to get ver3 out. The envelope method works just fine, |
|
| Back to top |
|
|
Sheppol_A
PhD in Jamology
Joined: 04 Dec 2008
Posts: 425
|
| Posted: Sat Mar 20, 2010 4:44 pm Post subject: |
|
|
I know it's not strictly how you may want to work but I now keep several small parts/bars saved with things like a stock beat with a side-stick instead of a normal snare.I can then load these in and change at will.
Arrow Head in Bar editor/Save Bar/Load Bar.I have done the same with cowbells etc.I know I'm going to use them again at some point in the future so I sat and made several for re-use.
HTH  |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
