Rayzoon Technologies LLC

[J van E]

Well, this one will be VERY hard to describe, but I'll do my best.

As soon as I right-click on the control body (a slider) in the Brain I can choose a MIDI controller. But when I leave that MIDI controller window (by clicking cancel or OK) the slidercontrols automatically follow the mouse! They SNAP to it! This means that if I just move my mouse over a part of the slider, the button snaps to that position! This ONLY goes for the specific controls I have right clicked. When I CLICK in a specific slider, the following stops.

When I do not click and the buttons follow the mouse, and I change from Groove to Accent and back again, not only do the buttons not follow the mouse anymore, but they are also reset to where they were before...

Now the buttons follow the mouse automatically and I simply move the mouse up and down ABOVE those sliders, the two slider buttons jump to where the mouse is. Due to this I can't see anymore where the position was and should have been (providing I didn't want to change it) and I have to go to Accent or Fill and back to have them reset again. (The percentages at the bottom also show the position of the mouse/slider, so that's no help either.)

I told you it was difficult to explain... Hope you understand what the problem is...

[Ralph [RZ]]

Got it. We're on it. For now, please right-click on the body of the slider, not the slider head and the mouse capture problem won't happen.
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com