| View previous topic :: View next topic |
| Author |
Message |
Jae.Thomas Grand Master Jam

Joined: 06 Jun 2006 Posts: 280
|
Posted: Thu Apr 04, 2019 10:17 am Post subject: linked parts and fills/accents |
|
|
is it possible to have linked parts and yet vary the fills/accents on each?
IT seems so, but I just don't want to mess this up.
It would be cool if there were an option - although some folks might want the same basic settings, they might want to vary up the fills |
|
| Back to top |
|
 |
Ralph [RZ] Site Admin

Joined: 02 Jan 2008 Posts: 13332
|
Posted: Thu Apr 04, 2019 3:00 pm Post subject: |
|
|
No, linked parts have the same accents and fills.
What you can do is wait until all the groove work is done and then un-link the parts and adjust the fills/accents as needed. Don't re-link them or they will be the same again. _________________ Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com |
|
| Back to top |
|
 |
Jae.Thomas Grand Master Jam

Joined: 06 Jun 2006 Posts: 280
|
Posted: Thu Apr 04, 2019 3:02 pm Post subject: |
|
|
cool! thanks!!!  |
|
| Back to top |
|
 |
|