Rayzoon Technologies LLC

[acabreira]

Something strange´s happening that´s rendering JS almost unusable to me: I work on an arrangement in a song in Cubase, then I close and reload the song and the arrangement changes in an unpredictable way, most noticeable inserting accents where there were none, supressing open hats, and the start bar that references the fills resets to 0. I tried to save the arranegement and load it within JS, setting the start bar again to where I desired, but it doesn´t work either. I´m not sure if I could be doing something wrong, but I just can´t seem to fix it.

[acabreira]

Forgot to say it doesn´t happen in the 1.3 release, only in the subsequent betas.

[Ralph [RZ]]

We'll be looking into it...
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

[Ralph [RZ]]

When you load your project, is Jamstix in free jam mode?
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

[acabreira]

No, I only use manual mode.

[acabreira]

To enlighen a little, when using 1.3 the reset bars would keep loading as reset, but with the betas it´s loading like they were set already.

[Ralph [RZ]]

Please try the X5-7 beta that was just released. It should properly load projects saved with 1.3 and not alter accents.

It may not load decision data from earlier X5 betas.

By the way, X5-7 also stores the fill start bar in the project data, which was another issue you mentioned.
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

[acabreira]

It seems to be in the right way, but there´s somethng: when it plays an accent in a bar, it sometimes plays a different tom even in the same session. I´ve started an arrangement from scratch, but loaded rhythms that I´ve created in previous betas, so maybe there´s an interference? I´ll be creating new arrangements to see if they keep consistent through sessions.

[acabreira]

Ralph, I think I found out something. The accents seem to be shifted everytime I start playing a session in the middle of a song. When I save a project and reopen, play it from the first bar, the arrangement is loaded correctly; when moving back and forth through the song while it´s playing, it keeps being played correctly, but as I stop and start at some point that´s not the start, then the arrangement seems to lose the accent references, like something is getting out of sync. Not sure you can reproduce this behavior.

[Ralph [RZ]]

[acabreira]

It´s working really well now, thanks, Ralph!