Rayzoon Technologies LLC

[steve_t]

Hi Everyone,
I have installed JS3 in Reaper and only get the sounds of some of the cymbals. I have the "downmix" set correctly. When I click on the drums in the kit window I am seeing the meter in Reaper respond. I have installed all the kits using install and the "JS2 Migration Tool"(just to make sure). I do have the power knob turned up.

Thanks for any help.
Steve

[Ralph [RZ]]

If the meter responds in REAPER then REAPER is getting a signal. There must be something muted in REAPER.
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

[steve_t]

Ralph,
I opened JS2 and used the same kit, style etc. and it worked fine. When I opened JS3 I still did not get sounds (some cymbals).

Steve

[Ralph [RZ]]

Could you send me the REAPER project?
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com

[Doc]

For troubleshooting:
Can you go to the mixer tab and select "Set Out put Routing- 1- Single Output? Does it change anything?

[steve_t]

Ralph,
I sent the file to the sales link( I'm new to these message boards). I have tried the "Set Out put Routing- 1- Single Output" with no luck.

Thanks for the help,
Steve

[steve_t]

Hi Everyone,
Stupid human trick -I didn't have the JS3 kits downloaded. Everything is working great.
Steve