Rayzoon Technologies LLC

music125music · Junior Jammer Joined: 16 May 2007 Posts: 19

I have flstudio7.01 how can i rout each individual sound from Jamstix to a separate track in fl7 mixer oh by the way incredible software and how do the drum paks compare to BFD drums or do i have to work thru FPC to achieve that also is there more tutorials on the way Thanks Very Happy

datapark · Junior Jammer Joined: 13 May 2007 Posts: 6

Willy4360 · Posted: Wed May 23, 2007 10:18 pm Post subject:

I don't how flstudio works, but JS has more than 4 output channels to route.

If you use the internal sounds or packs:

In the MAPPING tab first set the desire output channels you want in the SOUNDS section (I have 16 channels there).

Then, in the MAPPING section, on the left, on SOUNDS select KICK and there's a slider named OUTPUT down below, select the channel number you want for the kick and repeat for each piece of the kit (I have 17 channels available to route).

If you use another VST for sounds (BFD, EZDRummer) it must have multiple outputs.

Hope this helps.

Willy.

GregHolmes · Posted: Thu May 24, 2007 11:34 am Post subject:

After changing the number of channels in Jamstix, make sure to un-load and re-load it from your host, so the host knows about all the channels. VST hosts usually only check for the number of output channels when a plugin is first loaded.
_________________
Dealer for AccuGroove, Acoustic Image, BassLab, Eminence, Muse Receptor, MIDIjet, Rayzoon, and more...
http://www.ghservices.com/
http://www.gregholmes.com/
My used gear for sale http://www.ghservices.com/products/used/

music125music · Junior Jammer Joined: 16 May 2007 Posts: 19

yes that helps alot thanks all i will make sure the host unloads and reloads thanks Very Happy