| View previous topic :: View next topic |
| Author |
Message |
rockreid
Junior Jammer
Joined: 02 Jan 2007
Posts: 11
|
 Posted: Tue Jan 02, 2007 2:13 pm Post subject: Sonar 6 w/ BFD Help with Splitting Outputs |
 |
|
Sonar 6 inserts Jamstix tracks (I have Jamstix set up for 16 outputs right now to handle BFD 1.5 ALL outputs mode) but they are all Stereo tracks. I need to split some of the stereo tracks (Kick for instance) into separate Mono tracks. How do I do this? The Inputs in Sonar only list stereo Jamstix outputs as sources. Is there a way to tell Jamstix to output Mono tracks?
So far I have jamstix working great w/ BFD 1.5 except for the Sonar tracks issue. I am a noob w/ Jamstix but followed the instructions in the Jamstix manual for Mapping BFD outputs and restarting Jamstix after increasing my ouputs. Thanks for any help;. |
|
| Back to top |
|
 |
Ralph [RZ]
Site Admin
Joined: 02 Jan 2008
Posts: 13332
|
| Posted: Tue Jan 02, 2007 4:16 pm Post subject: |
|
|
Since you have Sonar 6 you have two options:
a) Add this line to the [General] section of the jamstix.ini file in the Jamstix folder to get mono outputs:
StereoOutputs=0
b) Run BFD outside of Jamstix in Sonar and drive BFD by adding a MIDI track with input=Jamstix and output=BFD. This assumes you have the MIDI output support in Sonar 6 enabled for Jamstix. You may also want to load a BFD mapping into Jamstix with 'MIDI Out Only' checked so that Jamstix uses BFD key format even though it doesn't actually load BFD.
_________________
Ralph Zeuner
Rayzoon Technologies LLC
http://www.rayzoon.com |
|
| Back to top |
|
|
rockreid
Junior Jammer
Joined: 02 Jan 2007
Posts: 11
|
| Posted: Tue Jan 02, 2007 4:21 pm Post subject: thanx-will give suggestions a try. |
|
|
| sure I'll be posting quite a few qeustions, but so far Jamstix is just the software I was looking for. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
